Steam generators for the production of metal fittings

Welding wire is used as filler metal or as conductive wire welding material. In gas welding and gas tungsten shielded welding, the welding wire is used as the filler metal; in submerged arc welding, electroslag welding and other MIG arc welding, the welding wire is both the filler metal and the conductive electrode. The wire surface is not coated with anti-oxidation flux.
Welding wire can be divided into rolling, casting, cored and so on. Production unit A is mainly engaged in manufacturing, and its service area is the production of metal products such as welding wire and welded pipe. After a national investigation and investigation, two 1-ton flow chamber full premixed steam generators were finally selected. The installation and debugging have been completed. The equipment is operating normally and the steam volume is sufficient.

During the welding wire production process, the steam generator mainly provides heat source steam for it. The fully premixed steam generator in the flow chamber adopts the fully premixed surface combustion technology. Fuel and air are thoroughly mixed before passing through the combustion rods for maximum premixing. At the same time, the flame of the metal fiber combustion rod is short and uniform, which heats the cold water quickly, and can achieve dry saturated steam output without preheating. It can be used after opening, which greatly improves the production efficiency.
Not only that, in the product distillation process, the steam generator uses high-temperature steam above 180 degrees Celsius, which will not produce any harmful substances and impurities, which ensures the quality of the product, is practical, economical, energy-saving, and environmentally friendly, and can create higher economic benefits for the enterprise.